Home Page › Forum › Community International › Archive › Automation › F411/4 and F411/2 turning on only by Group but not by Area/Light
Questo argomento contiene 4 risposte, ha 4 partecipanti, ed è stato aggiornato da dchramcow 31/03/2016 at 21:14.
So quick question guys, I have a couple of F411/4s and F411/2s that are not turning on/off when being called by their respective Area and Light Point, only when being added to a certain group.
What could be causing this? Thanks.
Maybe wrong number configuration? or maybe mixed up area and light point number?
check the configuration.
In which way you have configured them?
Verify if you are connected to the wrong side of one physical expansion interface, in this case the order point to point do not reach the device but general orders like group can do it.
Thanks for all the suggestions.
It was indeed connected to the wrong side of one of the physical expansions, after changing it, it all started working properly.
Devi essere loggato per rispondere a questo argomento.