Home Page Forum Community International Archive Automation F420 – problem with programming.

Automation
F420 – problem with programming.

Questo argomento contiene 3 risposte, ha 3 partecipanti, ed è stato aggiornato da  rphopkins 11/04/2016 at 10:00.

0
3
711
  • Verificato

    Hi There,

    I have a problem with programming of module F420. I want to set a scenario for shutter. The scenario has to stop the shutter, when it moves up or down. When I start the shutter and activate the scenario, nothing happens(the shutter continue moving) I did the scenario with ScenarX program. I tried a composite scenario – turn off lamp and stop the shutter. The result is: the lamp turns off but the shutter does not stop. When the shutter is moving and I send a command via ScenarX program the shutter stops. What could be the problem? In bus monitor also I can't see the command for stoping from F420 module. The command which I use is *2*0*addres##




    Utente
    Bararov
    Ruolo
    Installatore
    15 posts
    Verificato

    Hi, try to memorize the scenario directly on the bus command without using scenariX.

    Maybe the problem is on the gateway or on the connection and not on the scenario

    Regards




    Utente
    BT_Marcog
    Ruolo
    Legrand/BTicino Group
    4593 posts
    Verificato

    Ok, but the result is the same. I tried to send command with key for stopping the shutter. Down you can see the log from bus monitor:

    11.04.2016 09:45:40     192.168.1.35     MON     RX     Data received     *0*40#15*02##    

    11.04.2016 09:45:48     192.168.1.35     MON     RX     Data received     *2*1000#0*17##    

    11.04.2016 09:45:48     192.168.1.35     MON     RX     Data received     *2*0*17##    

    11.04.2016 09:45:50     192.168.1.35     MON     RX     Data received     *1000*1001*0##    

    11.04.2016 09:45:50     192.168.1.35     MON     RX     Data received     *0*41#15*02##    

    The scenario number is 15 address of F420 is 02 and the address of shutter is 17.




    Utente
    Bararov
    Ruolo
    Installatore
    15 posts
    Verificato

    Hi Deian Bararov

    From my memory I don't believe it's possible to learn the stop command. I would imagine this is due nature of the device not supporting timing delay and therefore capturing the stop command would add no benefit.




    Utente
    rphopkins
    Ruolo
    Legrand/BTicino Group
    566 posts
Stai vedendo 4 articoli - dal 1 a 4 (di 4 totali)

Devi essere loggato per rispondere a questo argomento.